Profiled elements
Some timber arrives already profiled. An MM HBE element is a glulam beam of 360 × 100 with a double tongue and groove on its long sides, and a 20 × 30 groove on each side. Laid side by side, the two grooves make a 20 × 60 cable duct. Boomkikker draws such a beam with its profile, but leaves the profile out of every machine file: the factory has already made it.
Choose the profile
Section titled “Choose the profile”- Select a part, and next to Profile choose + new to open New profile.
- Under Factory-profiled, choose MM HBE 360 × 100.
- Choose Add. The part is drawn with its tongue on the front and its grooves on the back.
Build a run of elements
Section titled “Build a run of elements”Open My library and choose MM HBE elements. Set the length, the number of elements, and whether they lie (a roof or floor) or stand (a wall). The elements are placed 345 mm apart, centre to centre, with every tongue in the next element’s groove.
Elements you place yourself are checked too. Two elements of the same profile side by side are coupled when they are 345 mm apart and their tongues point the same way. Otherwise both say what is wrong:
- the seam is open or too tight, and by how much;
- a tongue meets a tongue, or a groove meets a groove.
Start and end pieces
Section titled “Start and end pieces”Where a wall ends or turns a corner, the profile is sawn off along the whole length so the element ends square. Open Add on the part and choose Rip along the back (the groove side) or Rip along the front (the tongue side). The strip includes the duct half plus 2.5 mm, so ripping both sides leaves a solid 280 × 100.
Sockets on the seam
Section titled “Sockets on the seam”A wall socket sits on the cable duct, right on the seam between two elements, so each element needs half of it. Select the two elements; when they are coupled the panel shows Cutout on the seam. Choose round or rectangle, the face, how far from the start of the element with the tongue, the size and the depth, and choose Add cutout on the seam. Each element gets its half, placed to the millimetre.
A round cutout is written as a bore with its centre on the element’s edge, half of it in air; a rectangle as a contour that stops at the edge. A half circle on the edge of a part in a Rhino model is read the same way.
For a double socket choose Round, double. The first hole sits on the seam as above; the second is a whole hole in one of the two elements, further in from the seam by the Centre to centre distance. Set the diameter and that distance to your socket (71 mm is the default), and choose which element gets the second hole.
What the machine file holds
Section titled “What the machine file holds”The tongue, the grooves and the duct are never written: the beams arrive profiled. Every export lists the profiled parts in one note. Planing on a profiled part gets its own note: it would plane the profile off, and the beams are planed to size before machining.